cisco ap >> ERROR!!! Command is disabled.

喔我好強XD

1. 刪除現有的ios,讓他回復到最初機器上面的
2. clear pre-config


ERROR!!! Command is disabled.

出現這訊息,就不用在ap上踹了,直接到controller的web介面
找到這台ap的mac 或hostname, 直接在上面修改 hostname or ip等資訊
收工~

若硬要console設定ap 下文說是需要給ap一組username/password
我沒試過..因為上面做完就收工了.

Q. When I enable some LWAPP commands on my LAP, I get an error that says the command is disabled. Why is this?

 
AccessPoint#clear lwapp ap controller ip address 
ERROR!!! Command is disabled.

A. Once your AP has successfully joined a controller, the LWAPP commands are disabled. In order to enable LWAPP commands again, you must set the username/password of the AP from the controller CLI with the config ap username <name> password <pwd> <cisco-ap>/all command. Once that is done, you can do a clear lwapp private-config in the AP CLI to allow you to manually re-issue the AP LWAPP configuration commands.
Note: If you are running WLC version 5.0 and later, use this command to set the username and password on the AP:

config ap mgmtuser add username AP_username 
password AP_password secret secret {all | Cisco_AP}

cisco ap ERROR!!! Command is disabled.